Hp procurve 24 port switch manual

Management and Configuration Guide www.doorway.ru ProCurve Switches QXX.  · HP ProCurve PoE Switch It describes how to use the command line interface (CLI), Menu interface, and web browser to configure, manage, monitor, and troubleshoot switch opera­ tion. For an overview of other product documentation for the above switches, refer to “Product Documentation” on page xi. Introducing the Switch 1 Introducing the Switch The ProCurve Switch is a multiport switch that can be used to build high-performance switched workgroup networks. These switches are store-and-forward devices offering low latency for high-speed networking. The Switch has 24 auto-sensing 10/Base-TX RJ ports, two dual-.

The HP ProCurve al Switch Series consists of four switches: the HP ProCurve alG and alG-PoE+ Switches with 24 10// ports, and the HP ProCurve alG and (port switches) and Gbps switching fabric with up to million pps (port switches) • Selectable queue configurations: increase. Introducing the ProCurve Series zl Switches Introducing the ProCurve Series zl Switches Switch zl, Switch zlG. The Switch zl is available as an open slot chassis (JA) and as the Switch zlG bundle (JA) with four port 10//T zl Modules pre-installed. Figure ProCurve Switch zl (JA). JA HP SWITCH; JA HP PPOE SWITCH; JA HP POE SWITCH (vlan)# exit Remove a port from a VLAN (In this case the utagged default-VLAN #1 from port 26) ProCurve# config ProCurve(config)# vlan 1 ProCurve(vlan-1)# no untagged 26 Note: remove tagged port 'no tagged 26' Delet a VLAN no vlan ProCurve Switch.

switch ports, the ProCurve Switch G uses a Mode LED for each port. The operation of this LED is controlled by the LED Mode Select button on the switch panel, and the current selection is indicated by the mode indicator LEDs near the button. Press the button to change from one mode to the next. System LED State Meaning Power (green). configure the trunk instead (trunks are labelled T1 to T12 for the 24 port switch, and T1 to T4 for the 8 port switch). Creating a VLAN 1. Use the VLAN Setup page to create VLANs on the Switch. In VLAN ID, input a number from 1 to 2. Click ADD. 3. Select the ports to be a member of this VLAN. 4. Click APPLY. Switch Series www.doorway.ru Hello, i'm tring to reset to factory a hp procurve g but i cant. i read the manual: to execute the factory default reset, perform these steps: 1., hp procurve g port layer 2 managed gigabit switch w/ 4x combo gigabit sfp uplinks - ja, specifications.