Ice device user manual

Open the cover, remove the ice basket and pour normal tap water into tank. Keep water level below the level mark. 3. Plug in the unit and the power indicator light will blink. 4. Press “POWER” on the control panel to begin the ice making cycle. The power indicator light will light. 5. Select the size of the ice cube by pressing the “SELECT” button. Purpose of This Manual viii ICE/ICE Emulator User’s Guide Purpose of This Manual The ICE/ICE Emulator User’s Guide provides directions for installing the emulator hardware and software on your PC. Intended Audience This manual is intended to File Size: KB. User manual Superheat control for unipolar electronic expansion valve. 3 ENG EVD ice is an electronic superheat controller for Carel unipolar expansion The device also has a user interface that displays the instant superheat value at all times, signals any .

User manual Superheat control for unipolar electronic expansion valve. 3 ENG EVD ice is an electronic superheat controller for Carel unipolar expansion The device also has a user interface that displays the instant superheat value at all times, signals any alarms, and above all can be used to set the. Device user manuals. The information on this page applies to the following Google Fiber devices: These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) these devices may not cause harmful interference, and (2) these devices must accept any interference received, including interference that. • The ice maker is designed to be installed in an outdoor kitchen, but must not be placed directly adjacent to a grill or other source of high heat. A minimum clearance of 6" from all sources of high heat must be maintained at all times. • The ice maker must be installed with all electrical and water connections in.

A-MCU/ USER GUIDE Atmel-ICE The Atmel-ICE Debugger. Atmel-ICE is a powerful development tool for debugging and programming ARM®Cortex®-M based Atmel®SAM and Atmel AVR®microcontrollers with On- Chip Debug capability. It supports: Programming and on-chip debugging of all Atmel AVR bit microcontrollers on both JTAG and aWire interfaces Programming and on-chip debugging of all Atmel AVR XMEGA®family devices on both JTAG and PDI 2-wire interfaces Programming (JTAG and SPI. ICE Version Show the firmware version of the connected Nu-Link ICE. Device Family Show device family supported by the driver. Device ID Show ID CODE of SWD in a target chip. Port Currently, the Nu-Link Keil® driver only supports “SW”, which means SWD port. Max Clock Select the maximum SWD clock rate. Chip Type. Ice production to lb. per 24 hours Water use* 41 gallons per 24 hours BTUs per hour* Refrigerant type R Refrigerant charge 14 oz Refrigerant pressures - hi; low Metering device Cap tube Average amps *90/70 Minor changes between A and B models; compressor change between B and C models; wiring changes between.